Install Anti-Tip Bracket; Important Safety Warning - IKEA LAGAN Manual De Instrucciones

1. Install anti-tip bracket

IMPORTANT SAFETY WARNING!

To reduce the risk of tipping of the range,
the range must be secured to the floor by
properly installed anti-tip bracket and screws
packed with the range. Failure to install the
anti-tip bracket will allow the range to tip
over if excessive weight is placed on an open
door or if a child climbs upon it. Serious injury
might result from spilled hot liquids or from
the range itself.
If range is ever moved to a different location,
the anti-tip bracket must also be moved and
installed with the range.
Instructions are provided for installation in
wood or cement fastened to either the floor
or wall. When installed to the wall, make
sure that screws completely penetrate dry
wall and are secured in wood or metal. When
fastening to the floor or wall, be sure that
screws do not penetrate electrical wiring or
plumbing.
Anti-tip bracket installation
instructions
a. Locate the bracket using the template -
(Bracket may be positioned on either the left
or right side of the range. Refer to Figs. 4, 5,
& 7 to position the bracket if template is not
available).
Mark the floor or wall where left or right side
of the range will be located. If rear of range is
against wall or no further than 1-1/4" from wall
when installed, you may use the wall or floor
mount method. If molding is installed and does
not allow the bracket to fit flush against wall,
remove molding or mount bracket to floor.
For wall mount (Fig. 4), locate the bracket by
placing the back edge of the template against
rear wall and the side edge of template on the
mark made referencing the side of the range.
Place bracket on top of template and mark
location of the screw holes in wall. If rear of
range is further than 1-1/4" from wall when
installed, attach bracket to the floor (See
Fig. 5).
8
(31.75mm)
Fig. 4
For floor mount, locate the bracket by placing
back edge of the template where the rear of the
range will be located. Mark the location of the
screw holes shown in template.
b. Drill pilot holes & fasten bracket - Drill
1/8" pilot hole where screws are to be located
(Fig. 6). If bracket is
to be mounted to the
wall, drill pilot hole at
an approximate 20°
downward angle. If
bracket is to be mounted
to masonry or ceramic
floors, drill 3/16" pilot
hole 1-3/4" deep. The
screws provided may be
used in wood or concrete
material. Use 5/16"
nut-driver or flat head screwdriver to secure the
bracket in place.
c. Level & position range - Level range by
adjusting the (4) leveling legs with a wrench.
Note: A min. clearance of 1/8" is required
between bottom of range and leveling legs to
allow room for bracket.
Slide range back into position (Fig. 7). Remove
lower panel or storage drawer to visually check
that rear leveling leg is inserted into and fully
secured by the bracket. For models with a
warmer drawer or broiler compartment, grasp
the top rear edge of the range and carefully
attempt to tilt it forward.
Fig. 7
(31.75mm)
Fig. 5
Fig. 6
AA-2195041-2