Know Your Pressure Washer - Briggs & Stratton GENERAC 2300PSI Manual Del Propietário

KNOW YOUR PRESSURE WASHER

Read this owner's manual and safety rules before operating your pressure washer.
Compare the illustrations with your pressure washer to familiarize yourself with the locations of various controls and
adjustments. Save this manual for future reference.
Recoil Starter
Fuel Cap
Nozzle Extension
Throttle Control Lever
Choke Lever
Air Filter
Adjustable Nozzle
Adjustable Nozzle — Always attached to nozzle
extension. Adjustable nozzle allows you to adjust spray
pressure and spray pattern.
Air Filter — Dry type filter element limits the amount of
dirt and dust that gets in the engine.
Automatic Cool Down System — Cycles water
through pump when water reaches 125°-155°F.Warm
water will discharge from pump onto ground.This system
prevents internal pump damage.
Chemical Injection Siphon/Filter — Use to siphon
detergent or other pressure washer chemicals into the low
pressure stream.
Choke Lever — Prepares a cold engine for starting.
Fuel Cap – Fill fuel tank with regular unleaded gasoline
here.
Generac Portable Products 2300 PSI Pressure Washer
High Pressure Hose
Spray Gun
Pump equipped with Automatic
Cool Down System
High Pressure Hose — Connect one end to water
pump and the other end to spray gun.
High Pressure Outlet — Connection for high pressure
hose.
Nozzle Extension - Attached to spray gun for more
convenient use.
Oil Fill/Dipstick — Check and fill with oil here.
Pump — Develops high pressure.
Recoil Starter — Used for starting the engine manually.
Spray Gun — Controls the application of water onto
cleaning surface with trigger device. Includes safety latch.
Throttle Control Lever — Sets engine in starting mode
for recoil starter and stops a running engine.
Water Inlet — Connection for garden hose.
4
Chemical Injection
Siphon/Filter
Oil Fill/Dipstick
Water Inlet
High Pressure Outlet