Warn PN 64500 Manual Del Usuario página 3

Step One: Safety First!
When installing your ATV winch system, read and
follow all mounting and safety instructions.
Always use caution when working with electricity
and remember to verify that no exposed electrical
connections exist before energizing your
winch circuit.
Figure 3: To install the complete kit, you will need to mount the winch, contactor,
and remote socket. Mounting locations may vary depending on make and model of the ATV. Read
and understand the following instructions to choose the appropriate mounting locations.
3 | Warn Industries, Inc.
Step Two: Winch Mounting
Attach the roller fairlead to the multi-mount plate, use
the provided:
• 3/8-16 x 3/4 in., hex bolts
• 3/8 in. lock washers.
• 3/8 in. hex nuts.
Secure the winch to the multi-mount plate, use the
provided:
• 5/16-18 x 1 in., grade 5 hex bolts.
Figure 4: Orientation of winch to
• 5/16 in. lock washers.
mounting plate.
• Torque bolts to 12 ft-lb (17 N-m).
Attach the clevis hook to the wire rope at this time.
• Put clutch in freespool position.
• Manually feed cable loop through the roller fairlead.
• Attach hook to cable loop and re-engage clutch.
Step Three: Contactor Location
• The contactor is a primary safety feature in your
winch system. It disconnects your winch from its
power source when the ATV is not in use. The
contactor must be correctly installed to work
properly.
• It is recommended that the contactor be
mounted close to the battery and in a location
that is as clean and dry as possible. Exact
location will vary, depending on the ATV. Usual
locations include inside, on top, or on the side of
rear storage box, and on a few models, under
the seat.
Figure 5. Contactor for the
WARN ATV winch
• Ensure the contactor mounting location selected
provides sufficient clearance from all metal
structures such as frame tubes. DO NOT place
tools or other items in a position that might come
in contact with the contactor directly.
• Drill the mounting holes for the contactor at this
time, then move on to step four as it will be
easier to attach all the wiring to the contactor
before attaching it to the ATV. DO NOT mount the
contactor at this time.
WARN 2.5ci Winch Multi-Mount Installation and Specification Guide |
4