Parallel Operation - Generac GP2500i Manual Del Usuario

2. Plug Battery Charging Cable into Battery
Charger Output jack, located on the con-
trol panel. See
3. Connect positive (+) battery clamp (red
wire) to battery FIRST.
4. Connect negative (-) battery clamp (black
wire) to battery SECOND.
NOTE: This receptacle can not recharge 6-
volt batteries and can not be used to crank an
engine having a discharged battery.
Figure 3-4. Battery Charger Input Jack
Environmental Hazard. Always recycle batteries at an
official recycling center in accordance with all local
laws and regulations. Failure to do so could result in
environmental damage, death, or serious injury.

Parallel Operation

For output power up to 4180W, two inverters
can operate in parallel using Generac's Paral-
lel Kit (optional). See the Parallel Kit Opera-
tor's Manual or contact an IASD.
NOTE: All connections to the parallel kit
should be made while both inverters are
turned off and all loads disconnected.
1. Make sure the Engine Economy Switch is
in the same position on both generators.
2. Make appropriate parallel connections to
the outlets on each Generac inverter as
outlined in the owner's manual supplied
with the kit.
NOTE: Do not disconnect any parallel kit con-
nections once the units are running.
3. Start both units per starting instructions.
Once the green output indicator illumi-
nates, devices can be connected and
turned on using the parallel kit outlet.
4. Follow Generator Shut Down
NOTE: For inverters, load applied to the paral-
lel kit is not to exceed 4180 watts due to a 5%
power loss when paralleling. See manual.
NOTE: Only use Generac approved parallel
kit.
12
Figure 3-4.
WARNING
instructions.
004469
(000228)
Owner's Manual for Portable Generator