Evenflo Reja de acceso a presión Instrucciones página 3

Assemble Gate with Extension
A
E
A
D
C
E
B
B
Installation
B A
B
1. Insert the top-of-gate and bottom-of-gate adjustment
bumper housings ( A and B , respectively) into the gate
, as shown.
C
2. Insert the extension D into the gate C
sure the plastic caps on the extension
touch each other. The plastic caps MUST touch each
other to securely install the extension.
3. Insert the top-of-gate and bottom-of-gate adjustment
bumper housings ( A and B , respectively) into the
extension , as shown.
D
4. Insert an adjustment bumper E into each of the
adjustment bumper housings ( and
A
NOTE: Make sure the adjustment bumpers and thei r
housings are pushed in all the way.
B
1. Position gate A on floor in center of opening, making
sure that it is straight up and down (90º to the floor).
NOTE: Rubber contact pads may mark some mounting
surfaces.
2 . Pull out an adjustment bumper on either side of the
B
top or bottom of the gate until it touches the wall or
door frame, as shown. Repeat with the remaining
adjustment bumpers.
B
2
, as shown. Make
G
and the gate
D C
), as shown.
B
C
3. Gate Bottom: Turn both bottom adjustment bumpers
, as shown, until they contact the door frame or wall.
C
Check that the gate is still straight up and down, then turn
each adjustment bumper two more full rotations or until
E
tight.
4. Gate Top
• Hinge Side: Tighten the adjustment bumper
hinge side of the gate, as shown, until the gap between
the door frame or wall and the outermost edge of the
gate
the hinge side
• Handle Side: Tighten the adjustment bumper
handle side of the gate, as shown, until the gap
between the handle
F
cm).
5. Make sure the gate frame assembly is secure by firmly
shaking it. If it moves, it needs to be re-installed. Repeat
steps 2 through 5.
1/8" (0.32 cm)
C
A
1. To open the gate, gently push down on the tab
handle
is freed from the hole in the frame.
C
B
D
2. Lift the door
open.
3
Installation
D on the
is the same as that at the bottom of the gate on
E
F .
on the
G
and latch is 1/8 inch (0.32
H I
Gate Operation
on the
A
and slide the latch back until the metal pin
B C
D out of the bottom frame and swing it