Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

The System Setup menu
2
Select output resolution.
• AUTO – The resolution is selected
automatically according to the capacity of
the TV (monitor) connected by HDMI.
• PURE – The signals are output with the
same resolution as when input.
• 480p/720p/1080i/1080p – The signal is
output with the resolution specified here.
(480p means the resolution of 480p/576p)
3
When you're finished, press RETURN.
You return to the Video Parameter menu.

Aspect

Specifies the aspect ratio when analog video
input signals are output at the HDMI OUT
terminal. Make your desired settings while
checking each setting on your display (if the
image doesn't match your monitor type,
cropping or black bands appear).
1
Select 'Aspect' from the Video
parameter menu.
5.Video Parameter
a.Video Converter
b.Resolution
c.Aspect
Return
2
Select desired output aspect ratio.
• THROUGH – The input video signal is
output unchanged.
• NORMAL – Black bands will appear either
at top and bottom or on both sides.
3
When you're finished, press RETURN.
You return to the Video Parameter menu.
Note
1 • When set to a resolution with which the TV (monitor) is not compatible, no picture is output. Also, in some cases no picture
will be output due to copyright protection signals. In this case, change the setting.
• When a display is connected by HDMI, if this is set to something other than PURE and 480i/576i analog signals are input,
480p/576p signals are output from the component output terminals.
2 If the image doesn't match your monitor type, adjust the aspect ratio on the source component or on the monitor.
1
5c.Aspect
NORMAL
BD
DVD
[THRO U GH]
TV/SAT
[THRO U GH]
DVR/VCR
[ NO RM AL ]
VIDEO
[THRO U GH]
Return
2
06
51
En

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido