Publicidad
Idiomas disponibles
Idiomas disponibles
1. Trim or remove lower air dam. See Figure 2 If cutting, recommend
drilling 3/8" at corners to maintain radius for appearance.
3. Feed the coiled end of the pull wire through the bolt rearward
attachment hole in the side of the frame and out the access hole. Attach
carriage bolt and spacer (item 1 & 5) to the pull wire. Pull the pull wire with
fasteners into location through the hole. Leave pull wires attached. Repeat
the same process on the both frame rails.
©2015 Cequent™ Performance Products, Inc. -
2-5/8"[66.675]
1-1/2" [38.1]
]
3" [76.2
Printed in Mexico
2. Feed the coiled end of the pull wire through the bolt forward attachment
hole in the side of the frame and out the access hole. (Note: driver & passenger
side use opposite hole positions) Attach carriage bolt and spacer (item 1 & 2) to
the pull wire. Pull the pull wire with fasteners into location through the hole.
Leave pull wires attached. Repeat the same process on the both frame rails.
Coil end of
Access hole
pull wire
Rearward
attachment
4. Tape spacer (item 6) to rearward attachment location. See Figure 5.
Then push all fasteners back into the frame rail leaving the pull wire
attached and sticking out. See Figure 4
Sheet 4 of 15
65067NP
Forward
attachment
04-21-15
Rev. E
Publicidad
