Before Use - Kalorik PPG 36584 Manual De Instrucciones

Fax +32 2 359 95 50

BEFORE USE

This appliance runs on a battery pack of 2 x AA type
•
rechargeable batteries. The batteries are pre-installed in the
motor housing.
If the original batteries need to be replaced later, open the
•
batteries housing by sliding the 2 white tabs at the bottom of the
motor housing towards the centre. Slide the motor block out to
access the battery cavities.
Do not replace the rechargeable batteries with non-
•
rechargeable ones, as these could catch fire.
If the rechargeable batteries need replacing, only do with a
•
rechargeable battery pack of the same type and specifications
(Ni-Mh type, AA size, 650mA)
To fill in pepper or salt:
Simply lift off the lid of each container and fill
•
them with coarse sea salt, peppercorns of
other spices suitable to be ground (fig. 4).
Put the lid back in place to keep the content
•
fresh and dry, until ready to grind.
Do not fill the containers completely, for best
•
performance.
CHARGING
Remove the grinder and components from the packaging.
•
Plug the charger cord into the charging base, and plug charger
•
into the socket
With the socket for the adapter at the right back side, and the
•
grind switch on the motor block position towards the front, place
the motor block on the center of the base and turn the motor
block clockwise, until it locks in place and a red pilot lights on the
base lights up.
Charging will take approx. 3-4 hours for the first time.
•
For longer battery life, leave the grinder to charge for up to 8
•
hours continuously. Then unplug the adapter from the socket and
discharge the batteries to the maximum before recharging.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
Assembly page 4/18
special instruction from Team
Print only
USK PPG 36584 - 110622