Fagor PLC-900 Manual De Instrucciones página 18

interior 5/2/02 09:19
• With the filling opening uncapped,
switch on the boiler until the water-
vinegar solution starts boiling.
• Switch off the appliance and wait 5 to 10
minutes, then rinse two or three times.
• In case of intensive use, rinse the boiler
occasionally to eliminate residue.
5. USEFUL HINTS TO SAVE ENERGY
Start by ironing garments that require lower
temperatures.
When all the garments are to be dry ironed,
we recommend that you follow the guidelines
in paragraph a) Dry Ironing, if the boiler will
not be switched on, there will be a energy
saving.
If some garments are to be dry ironed and
some garments are to be steam ironed, we
recommend proceeding as follows:
First: fill the boiler with water, as shown
previously and then, follow the points in
paragraph a) Dry Ironing. When you are
about to finish dry ironing, switch on the
boiler, so that it will be ready when steam is
needed.
6. USEFUL HINTS
FOR SUCCESSFUL IRONING
You can restore the original appearance and
softness of materials like velvet, wool, etc., as
well as gloves and bags, by passing the iron
over them, slowly, from a short distance,
using the steam.
Rugs will look as good as new, free from
furniture imprints, if you allow the steam to
penetrate where the surface has been
flattened and brush it gently.
Do not rest or use the iron on zips, zippers,
hooks, rings, etc., in order to avoid
scratching its base.
The surface of the base must always be kept
clean: to clean it, you need only to pass a
damp cloth over the surface when it is cold.
Do not use decalcifying agents.
After use, let the iron cool before storing it.
Store the iron in a dry place.
All manuals and user guides at all-guides.com
Pgina 16
It is not necessary to empty the water tank
after finish ironing.
Separate the garments, according to the
temperature required for ironing, starting
with those which require lower temperatures.
Silk garments should be ironed inside out.
Garments in wool, cotton and fine linen may
be steam ironed inside out or in the outside,
by inserting a damp cloth to avoid them
looking "shiny". Starched materials need to
be dampened more. White and light
coloured material should be ironed on the
outside and dark coloured material and
embroidery should be ironed inside out.
Linen garments, should be steam ironed,
using abundant steam and dark garments
should be ironing inside out, to avoid them
looking "shiny". Iron the lapels on the outside
to give greater contrast.
This appliance is guaranteed for one year
from time of purchase, against any
manufacturing defect.
The guarantee will be annulled if the damage
has been caused by incorrect use or
handling by anyone other than Fagor
Technical Services personnel.
Whenever guarantee services are requested,
the Guarantee Card must be presented with
the date of purchase and the seller's stamp.
The guarantee holder always has the
statutory rights recognized by law.
The manufacturer reserves the right to
modify the models described in this User's
Manual.
17
7. GUARANTEE