RIDGID R4091 Manual De Operador página 16

ASSEMBLY
INSTALLING THE MITER GUIDE
See Figure 14.
The miter guide can be used from both the left and right side
of the cutting wheel.
 Place the slot on the underside of the miter guide on the
sliding table fence.
 Lock the miter guide securely to the table by turning the
miter guide knob clockwise.
To adjust angles:
 Loosen the lock knob.
 Set to the desired angle by moving the guide left or right.
 Tighten the knob securely before turning on the saw.
INSTALLING WATER PUMP AND WATER TANK
See Figures 15-16.
Plastic hose clamps secure clear tubes to the leg stand. To
attach a plastic hose clamp, slide the end of the clamp into
the holes on the leg stand upper tube.
 Fill the water tank to the two-thirds level of the tank.
 Center the water tank on the lower brace of the leg stand
and push the tank firmly against the center brace until it
locks into place.
 Secure with a hose clamp.
 Attach the clear tube to the submersible water pump and
set the pump in the bottom of the water tank.
 Push back rubber boot on electrical cord and plug pump
into an outlet or extension cord. Pull boot over cord
connections to help keep water off the plug.
 Check for leaks.
MITER
LOCK
GUIDE
KNOB
MITER
GUIDE KNOB
SLIDING
TABLE
FENCE
Fig. 14
16 — English
HOSE CLAMP
(PLASTIC)
RUBBER BOOT
Fig. 15
WATER PUMP
Fig. 16