Komet K Serie Manual De Instalación Y Mantenimiento página 4

To carry out a correct installation, it is advisable to follow the following instructions:
Ensure that no element of the equipment has been damaged in transport.
•
Check that the reducer is the one requested on the order form.
•
Fix the reducer firmly on flat surfaces or better, still directly onto the hollow axles, avoiding any
•
vibrations.
Under no circumstances should a mallet be used to assemble or disassemble parts in the axle ( pulleys,
•
pinions, ets) or use tie bars or extractors, using the threaded hole that is for the axle ends.
Tolerance of protrunding axles j
•
Tolerance of hollow axles H
•
Under no circumstances should the reducer be used for any other purpose than that for which it has
•
been ordered. For any variation should be discussed with our technical dept.
If in the installation predicts overloads, blows or blockades is advisable to install mechanical or
•
electronic restrictors of pair.
To install, predict sufficient distance between the motor fan and wall or chassis to guarantee the motor
•
takes enough air for its cooling.
For installation in wet environments or elements is advisable to have predicted the protection of the
•
reducer as well as the motor. (IP 55 & IP65)
In applications with numerous starts, stops and investments is advisable to block the setscrew.
•
The reducers with lubrication for life don't need maintenance, for the others is necessary to change
•
every 300 or 400 hours, and in the succesive, every 3000 hours of operation.
It should be avoided the placement of any oil not advised, as well as the mixture of mineral oils with
•
synthetic.
In the case of painting the group must be protected seals and machined settlements.
•
Environmental management of the product:The environmental regulation ISO 14001 recommends following the
intructions below when scrapping the motor reducer.
The parts for scrap need to be delivered to campanies authorised to collect metallic materials.
•
Oils and greases need to be delivered in treatment centres.
•
Wood, cardboard, plastic and paper need to be delivered to recycling companies.
•
Instalación/Installation/Installation
6
7
4