Start-Up; Setting Up The Scale - ADE Holly BE 2004 Instrucciones De Operación

Start-Up

Removing iso-strip
The battery is already inserted upon delivery and fitted with an iso-strip to prevent it
from discharging ahead of time. In order to start up the scale, you must remove the
iso-strip.
The battery compartment is located on the underside of the device.
1. Open the battery compartment.
2. Pull out the iso-strip.
3. Replace the battery compartment cover.
Choosing the unit of measurement
The standard unit of measurement upon delivery is "kg" (kilogramme). The
measurement result can also be displayed as "lb" (pounds) and as "st:lb"
(stones:pounds).
1. To switch on the scale, step on the middle of the weighing surface.
2. Use the UNIT button on the back of the scale to set the desired unit of
measurement. Note the display.

Setting up the scale

1. Place the scale on an even, firm and dry surface. Do not place the scale on a carpet.
2. First, briefly step onto the middle of the weighing surface to calibrate the scale. As
soon as the display shows "0.0", calibration is complete.
This calibration must be performed after each battery change.
BE 2004 bathroom scale
Start-Up
17