Matrix INDOOR CYCLING LIVESTRONG E Serie Manual Del Usuario página 27

2. To maintain the easy adjustability of the
resistance system, the screw threads on the lower
end of the brake rod should be lubricated. First,
turn the resistance knob clockwise until it stops.
Next, look under the right or left side of the frame
and locate the brake rod & . Apply a small amount
of synthetic grease (white lithium grease) to the
thread on the brake rod. Then, turn the resistance
knob counter-clockwise until it stops.
3. Some parts of the LIVESTRONG E-Series may
become loose as a result of repeated use. Check
pedals, toe clips, and pedal straps, and make sure
that they are properly tightened. Next, check all
exposed screws, bolts, and nuts, and make sure
that they are properly tightened. Finally, check the
saddle to make sure that it is not lose damaged.
4. The brake pad will become worn as a result of
repeated use. The LIVESTRONG E-Series should
not be used if the emergency braking system is not
working properly (see page 13)! Should you feel that
WKH UHVLVWDQFH V\VWHP¶V IXQFWLRQV DUH GH¿FLHQW LW LV
HVVHQWLDO WR ¿QHWXQH WKH UHVLVWDQFH V\VWHP EHIRUH
the bike is used again! Please check the setting of
the brake system as follows: First turn the resi-
stance regulator on the brake system as far as
it will go to the left (minimum braking effect). If the
VHWWLQJ LV FRUUHFW WKH EUDNH SDGV VKRXOG EH ÀXVK
ZLWK WKH À\ZKHHO DQG EDUHO\ WRXFKLQJ VR WKDW LW¶V
possible to cycle with a hardly noticeable amount
of resistance. The brake pad can be adjusted using
a 10 mm wrench. Next, check the brake pad for
signs of wear. If the brake pad does show signs of
excessive wear, thoroughly soak the brake pad
with lubricant spray using the 2 lubrication holes
% , and then wipe
Version 1.1 SBLS Copyright by Indoorcycling Group GmbH 2010
PREVENTATIVE MAINTENANCE
the excess off.
|
www.indoorcycling.com
2
C
5
6
C
ENG 27