Testing The Washer - LG WT7305C Serie Manual Del Usuario

• Connect this appliance to a grounded outlet
conforming to the rating prior to use. Failure to
do so may result in fire, electric shock, or
malfunction.
• Do not damage or cut off the ground prong of
the power cord. Doing so may cause death, fire,
electric shock, or product malfunction.
• Improper connection of the equipment-
grounding conductor can result in risk of electric
shock. Check with a qualified electrician or
service technician if you are in doubt as to
whether the appliance is properly grounded. If it
does not fit the outlet, have a proper outlet
installed by a qualified electrician.
• The appliance and outlet must be positioned so
that the plug is easily accessible.
• Do not use adapter or extension cords. Doing so
may result in serious injury, fire, electric shock,
or death.
• For best performance, plug the appliance into its
own individual outlet. This helps prevent
overloading house wiring circuits which could
cause a fire hazard from overheated wires.
• If necessary, use a new, UL-listed 3-prong
(grounding) plug rated at no less than the
branch circuit. Do not use an extension cord
longer than 3 feet. Failure to follow these
warnings may result in serious injury, fire,
electric shock, or death.

Testing the Washer

Check if the washer is properly installed and run a
test cycle.
1
Make sure that the tub is empty. Do not load
anything in the tub for this test.
2
Press the Power button.
3
Press and hold the Spin and Soil buttons
simultaneously until an
the display.
• is displayed first, and
1N
displayed.
• : Initial test
1N s
• : Previous test result was good.
1N sO
• : Previous test ended with an error.
1N sE
• The indication is different for each model.
code appears in
1N s
, , or is
s sO sE
4
Press the Start/Pause button.
• The test will run for about 3 minutes.
• The test automatically checks the water
inlet hoses and the drain hose.
5
Check the display for results.
6
At the end of the test cycle,
display. The washer will shut off automatically
after a short delay.
Installation Check Error Codes
Refer to the chart below before calling for service.
Error Code
• Fully open the water faucet.
IE
• Straighten out any kinks in the
inlet hoses and make sure the
hoses are not pinched against
the wall or under the washer.
• Straighten out any kinks in the
OE
drain hose and make sure the
hose is not pinched against the
wall or under the washer.
• Remove and flush out the drain
hose to remove clogs.
• Adjust or repair the drain.
Maximum drain height is 96
inches.
INSTALLATION 15
or will
ENd O
Solution