Technical Data; Noise Information; Vibration Information - Ratio PRO XF35J Manual De Instrucciones

TECHNICAL DATA

Type PRO XF35J (PDI-designation of machinery, representative of Impact Drill)
Voltage
Power input
No load speed
Impact rate
Impact energy
Chuck type
Drilling capacity max
Steel
masonry
Wood
Protection class
Machine weight

NOISE INFORMATION

A weighted sound pressure
A weighted sound power
K & K
PA WA
A weighted sound power

VIBRATION INFORMATION

Vibration total values (triax vector sum) determined according to EN 60745:
Hammer drilling into concrete
chiseling
The declared vibration total value may be used for comparing one tool with another, and may also be
used in a preliminary assessment of exposure.
WARNING: The vibration emission value during actual use of the power tool can differ from
the declared value depending on the ways in which the tool is used dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained
To use the correct accessory for the tool and ensure it is sharp and in good condition.
The tightness of the grip on the handles and if any anti vibration accessories are used.
And the tool is being used as intended by its design and these instructions.
This tool may cause hand-arm vibration syndrome if its use is not adequately managed
WARNING: To be accurate, an estimation of exposure level in the actual conditions of use
should also take account of all parts of the operating cycle such as the times when the tool is
switched off and when it is running idle but not actually doing the job. This may significantly reduce the
exposure level over the total working period.
28
Vibration emission value a
Uncertainty K = 1,5 m/s²
Vibration emission value a
Uncertainty K = 1,5 m/s²
230-240 V~50 Hz
L
= 16.415 m/s²
h,ID
= 16.081 m/s²
h,D
1050 W
0-1050 /min
0-5000/min
3.5 J
SDS-plus
13 mm
26 mm
40 mm
/II
3.2 kg
L : 91 dB(A)
pA
: 102 dB(A)
wA
3.0 dB(A)