Technical Data; Noise Information; Vibration Information - Ratio ML400M Traducción De Las Instrucciones Originales

tecHnicaL data

Type ML400M (PDH--designation of machinery, representative of rotary Hammer)
Rated voltage
Rated power
Rated no load speed
Impact frequency
Rated impact energy
Chuck type
Drilling capacity max
Steel
masonry,
wood
Protection class
Weight

noise inFoRmation

A weighted sound pressure
A weighted sound power
K & K
PA WA
Wear ear protection when sound pressure is over 80dB(A)

vibRation inFoRmation

Vibration total values (triax vector sum) determined according to EN 60745:
Impact drilling into concrete
WArNING: The vibration emission value during actual use of the power tool can differ from
the declared value depending on the ways in which the tool is used dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained.
The use the correct accessory for the tool and ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti vibration accessories are used.
And the tool is being used as intended by its design and these instructions.
This tool may cause hand-arm vibration syndrome if its use is not adequately managed
WArNING: To be accurate, an estimation of exposure level in the actual conditions of use
should also take account of all parts of the operating cycle such as the times when the tool is
switched off and when it is running idle but not actually doing the job. This may significantly reduce the
exposure level over the total working period.
Vibration emission value a
Uncertainty K = 1.5m/s²
L
L
,HD = 10.77m/s
2
h
230V~50Hz
400W
0-1500/min
0-6600BPM
1.0J
SDS+
10mm
10mm
30mm
/II
1.3kg
: 87.5dB(A)
pA
: 98.5dB(A)
wA
3.0dB(A)
23