Andis WDT-1 Instrucciones De Uso Y Cuidado página 5

Battery Status
Low Battery
Warning
Charging
Blade Oil
Travel Lock
Turbo Mode
WET/DRY OPERATION
This product is IPX 5 certified for use with water. Product can safely be used in the
shower and with water or gels.
TURBO SPEED
This trimmer is equipped with a turbo speed function for use on thick, dense hair. To
activate, press the "T" turbo button below the power button. To return to standard
speed, press the "T" Turbo button again.
USING THE ATTACHMENT COMBS
(Some trimmer kits do not have combs and sizes will vary by kit)
The trimmer comes with two adjustable combs: a hair clipper comb and a beard comb.
To attach a comb, place the bottom edge of the comb into the slot on the trimmer and
push down until comb snaps into place (Figure B).
To adjust the trim lengths, turn the adjustment wheel on the side of the trimmer to the
desired setting. The trim length will appear in the trim length indicator; the top number
indicates length using beard comb; the bottom number indicates length using hair comb
(Figure C).
To remove the comb, hold the trimmer with the blade facing away from you. Firmly push
the bottom of the comb upward and away from the blade.
Hair Clipper Comb
Beard Comb
DIGITAL DISPLAY
Displays percentage of power left in battery until charge is required.
Red plug symbol will illuminate when the battery is less than 10%
charged, indicating charging is needed.
Red plug symbol will illuminate while battery is charging.
Red oil symbol will flash when the blade requires oiling or if
excessive hair is blocking the blade.
Red lock symbol will illuminate while in travel lock mode.
"T" Symbol will illuminate while clipper is in turbo mode.
ATTACHMENT COMB LENGTHS
Adjusts 20 settings from 3mm up to 12.5mm
Adjusts 20 settings from 0.5mm up to 10mm
5