User Maintenance - Andis WDT-1 Instrucciones De Uso Y Cuidado

TRAVEL LOCK FEATURE
This product is equipped with a travel lock feature. To enable the travel lock, press and
hold the power button for 3 seconds until you see the red lock symbol appear on the
digital display. To release the travel lock, press and hold the power button for 3 seconds
until the red lock symbol disappears.

USER MAINTENANCE

The internal mechanism of your trimmer has been permanently lubricated by the factory.
Other than the recommended maintenance described in this manual, no other
maintenance should be performed, except by Andis Company, or an Andis authorized
service station. To contact Andis directly, please call our Customer Support Team at
1-800-558-9441 or email us at support@andisco.com.
REMOVING AND REPLACING THE BLADE
When removing the blade, turn the trimmer OFF. Push the blade away from the trimmer
with your thumb, and the blade will pop off (Figure D). To replace or change the blade
set, fit the plastic tab on the blade set into the notch located at the bottom of the
trimmer opening. Firmly push the blade into the trimmer housing and it will snap into
place (Figure E).
BLADE TEMPERATURE
Due to the high speed nature of Andis trimmers, please check for blade heat often,
especially on close cutting blades. If blades are too hot, dip the blades only into Andis
Blade Care Plus or apply Andis Cool Care Plus and then Andis Clipper Oil.
CARE AND SERVICING OF YOUR ANDIS TRIMMER BLADES
Blades should be oiled before, during, and after each use. If your trimmer blades leave
streaks or slow down, it's a sure sign that the blades need oil. Hold the trimmer with the
blades pointing down to prevent oil from getting into the motor. Place a few drops of
Andis Clipper Oil on the front and side of the cutter blades (Figure F). Wipe excess oil off
blades with a soft dry cloth. Spray lubricants contain insufficient oil for good lubrication,
but are an excellent trimmer blade coolant. Always replace broken or nicked blades to
prevent injury. You can clean the excess hair from your blades by using a small brush or
worn out tooth brush. To clean the blades we suggest to immerse the blades only into a
shallow pan of Andis Blade Care Plus, while the trimmer is running. Any excess hair and
dirt that has accumulated between the blades should come out. After cleaning, turn your
trimmer off and start clipping again.
USE GUIDELINES FOR LITHIUM-ION BATTERIES
1. The lithium-ion battery included with your trimmer does not develop a "memory
effect" like a nickel-metal hydride (NiMH), or nickel cadmium (NiCd) battery. You can
plug the adapter cord into the trimmer at any time for a full charge, or even use the
battery before a charge cycle is complete. Like most rechargeable batteries, lithium-
ion batteries perform best when used frequently.
2. For maximum battery life, store the trimmer in a partially discharged condition if the
unit will be unused for several months.
3. Do not store trimmer under 50°F or over 104°F. Do not expose trimmer to excessively
damp conditions.
6