Table: Error Codes - NOVARDEN NRL630 Manual Del Usuario

EN
Troubleshooting
Table:
Error codes
Code Problems
STOP button
E1
activated.
Lift sensor
E2
activated.
Robot mower
E3 outside of
perimeter cable.
Perimeter
cable damaged,
E4
broken or
disconnected.
Bump sensor
E5
activated.
Possible causes
"E1" is displayed while the
STOP button is activated.
Carefully lift the robot
mower until the back
wheel lifts off the ground.
The blades stop for after
2 seconds and the front
wheels after 5 seconds.
The blades stop after
2 seconds of the robot
mower going over the
perimeter cable. "E3" is
displayed if the robot
mower cannot reverse.
The robot mower stops
immediately when
the perimeter cable is
damaged, broken or
disconnected.
1. The robot mower
collides with more
than 10 obstacles
with less than 10
seconds between each
collision.
2. The bump sensor is
activated for more
20
than 10 seconds.
Solutions
Place the robot mower
less than a metre away
from the perimeter
cable and restart it.
Check the perimeter
cable's condition. The
LED at the back of the
base must be steady
green. Place the robot
mower less than a
metre away from the
cable and restart it.
Remove the obstacles
and place the robot
mower less than a
metre away from the
perimeter cable, then
restart it.