Operation; Starting The Engine - Troy-Bilt FLEX 23AADAAA711 Manual Del Operador

Operation

WARNING!
When the FLEX™ Pressure Washer attachment is attached to the FLEX™ Power Base, the engine must only
be started after the water supply is connected and turned on with water flowing through the pressure washer. Failure
to have the water source connected with water flowing through he pressure washer prior to starting the engine of the
FLEX™ Power Base will cause irreparable damage to the pressure washer pump.

Starting The Engine

Refer to the FLEX™ Power Base's Operator's Manual for engine
starting and operating instructions.
Couple Pressure Washer Attachment to Power
Base
1. With the kickstand UP on the FLEX™ Power Base, as shown
in Figure 5-1, roll it over to the pressure washer attachment.
Figure 5-1
2. Tip the FLEX™ Power Base forward until the power base
hinge is in place under the mounting handle (1), and push
down firmly on both handles until you hear the Latch-n-
Lock™ System click into place (2) on the pressure washer
attachment. See Figure 5-2.
Note: The operator will be able to hear the Latch-n-Lock™
system engage and lock (latching sound) when coupled
properly. To test if coupled properly, lift up on the handles.
If the unit comes apart, the connection was not made.
Double check that the kickstand is still in the UP position,
and repeat steps 1 and 2.
Figure 5-2
Note: The operator will be able to hear the Latch-n-Lock™
system engage and lock when coupled properly.
Uncouple the Pressure Washer Attachment from Power Base:
Fully stop the Power Base engine before attempting to perform
any maintenance steps or uncoupling of the attachment. Never
attempt to uncouple the Power Base from the pressure washer
attachment WITH the engine running.
WARNING!
Always turn off the FLEX™ Power Base
engine and remove the key prior to attempting to
perform any maintenance or adjustments and/or
uncoupling of the Power Base from the attachment.
1. Position the kickstand down.
2. Tip the FLEX™ Power Base forward to disengage the Latch-
n-Lock™ mechanism, then the power base hinge.
3. Move the FLEX™ Power Base away from the pressure
washer attachment.
Note: With the kickstand deployed in the downward (unlocking)
position, the FLEX™ Power Base will rest comfortably in a parked
position.
5
1
2
11