Troy-Bilt FLEX 23AADAAA711 Manual Del Operador página 8

4. Uncoil and connect the other end of the high pressure hose
to the pressure washer main unit by threading the hose
onto the hose port as shown in Figure 3-4.
5. Attach the nozzle extension to spray gun by threading it
into the spray gun handle as shown in Figure 3-5. Firmly
hand-tighten the two components together.
Note: It may be necessary to use an adjustable wrench
to further tighten the nozzle extension to the spray gun
handle if the operator notices water seeping or leaking
from the connection point during operation. Be careful
not to overtighten. Do not use an adjustable wrench or
adjustable pliers to tighten either end of the high pressure
hose onto the spray gun or the main pressure washer unit.
8 S 3— A
ection SSembly
Soap Inlet Tube
Figure 3-4
Figure 3-5
& S -U
et p
6. Select the tip to use for the particular application this
pressure washer is to be used for. See Figure 3-6.
Note: See the Operation Section for more details regarding
each spray nozzle's usage.
0º
15º
yellow green
red
Figure 3-6
7. Install the desired spray nozzle into the end of the spray
handle assembly as shown in Figure 3-7. Simply align the
tip into the end of the spray handle and push. It will click
into place. See Figure 3-7.
Figure 3-7
8. To remove a spray nozzle, simply pull back on the spray
gun collar (A) in Figure 3-8.
40º
25º
Soap
white black