Troy-Bilt FLEX 23AADAAA711 Manual Del Operador página 13

3. Insert the five (5) multi–colored spray nozzles into the
color-coded spaces provided in the accessory tray.
4. Coil and hang the high pressure hose onto the hose
storage hanger, once both ends are detached from the
spray gun and the pressure washer pump.
How to Use Spray Nozzles
The quick–connect on the nozzle extension allows you to switch
between five (5) different quick-connect spray nozzles. Spray
nozzles can be changed while the pressure washer is running
once the spray gun trigger lock has been engaged. The spray
nozzles vary the spray pattern as shown. Refer to Figure 5-4.
Follow these instructions to change spray nozzles:
1. Engage the trigger lock lever on the spray gun handle.
WARNING!
The high pressure stream of water that
this equipment produces could cut through skin and
its underlying tissues, resulting in serious injury and
possible amputation. NEVER exchange spray nozzles
without the trigger lock being engaged on the spray
gun.
• DO NOT twist spray nozzles while spraying.
2. Pull the quick–connect collar back and pull the current
spray nozzle off. Store spray nozzles in the holder provided
on the accessory tray.
3. Select the desired spray nozzle:
• For delicate rinse, for gentle cleaning of cars/trucks,
boats, RV's, patio furniture, lawn equipment, etc.;
select the white 40° spray nozzle.
• For a little more pressure, ideal for dried-on debris;
select the green 25° spray nozzle.
• For general rinsing, ideal for most all purpose
cleaning such as home siding, brick patios, wood
decks, driveways and sidewalks, garage floors, etc.;
select the yellow 15° spray nozzle.
• For maximum rinsing, for stubborn or hard to reach
surface such as second story surfaces, paint removal,
oil stains, rust removal or other stubborn substances
(tar, gum, grease, wax, etc.); select the red 0° spray
nozzle.
• To apply detergent, apply project specific cleaners
to help break down stubborn dirt and grime on a
variety of surfaces; select the black detergent spray
nozzle.
4. Insert new spray nozzle by pushing it into the spray
nozzles. The spray nozzles are quick connect and simply
push-and-click into place. It is not necessary to pull back
on the nozzle collar to install the spray nozzles. Tug on
spray nozzle once installed to make sure that it is securely
in place.
0º
15º
red yellow green
Figure 5-4
Usage Tips
• For most effective cleaning, keep spray nozzle from 8 to 24
inches (20 to 61 cm) away from cleaning surface.
• If you get spray nozzle too close, especially when using
spray nozzles with less than a 400 fan.; you may damage
the surface being cleaned.
• DO NOT get closer than 6 inches (15 cm) when cleaning
tires.
25º 40º
Soap
white black
S 5 — o
ection peration
13