Troy-Bilt FLEX 23AADAAA711 Manual Del Operador página 9

A
Figure 3-8
Installing the Soap Inlet Tube
If planning to utilize the "Soap" tip, and apply soap using the
spray handle, follow these steps:
1. Remove the plastic cap on the soap inlet port of the
pressure washer pump, if not already done so. Refer to
Figure 3-1.
Note: If choosing not to install the soap inlet tube at this
time, the plastic cap on the soap inlet port of the pressure
washer pump may remain in place.
2. Install the two plastic hose clips packed with the soap inlet
tube, into the frame holes provided. See Figure 3-9.
Note: Clip types may vary, but all function the same.
3. Push the soap inlet tube onto the inlet port on pressure
washer pump. Refer to Figure 3-1 for location of where the
inlet tube attaches.
Figure 3-9
4. Route the soap inlet tube through the two clips installed in
Step 2. See the inset of Figure 3-9.
5. Install the bottle of soap into the soap holding tray and
insert the soap inlet tube into the bottle as shown in Figure
3-10. Soap bottle NOT included.
B
6.
7.
Your FLEX™ Pressure Washer is now setup and ready to be used
in a wide variety of applications. Proceed to the next section
in this manual to learn about the controls and operation of the
FLEX™ Pressure Washer.
Note: The soap inlet hose has enough additional length so
that instead it can be routed into a bucket that sits beside
the unit that contains a soap mixture.
Figure 3-10
A pressure control valve has been supplied to adjust the
pressure of the spray being dispensed through the spray
gun by the pressure washer. From the factory, the unit has
been set at maximum pressure. To lower pressure, rotate
knob counter-clockwise. See Figure 3-11.
Figure 3-11
If the pressure control has been lowered by turning the
knob counter-clockwise, then turn the knob clockwise to
increase the pressure.
WARNING!
Do not tighten or force the pressure
control knob once it reaches the stop at either end
of the pressure control spectrum. It is best to have
the knob slightly backed off in either direction once
reaching the stop either at min. or max. pressure.
S
ection
3 — A & S -U
SSembly et p
9