Klarstein 10034022 Manual Del Usuario página 14

EN
14
Components
Designation
Motor
Lower bar
Telescopic rod
Hanger
Clamps
Clamps with elastic cord
Shirt airbag
Trouser airbag
ASSEMBLY
1. Pull the mains plug out of the back of motor unit.
1
Drying Shirts
Install the two lower rods into the corresponding holes of the motor unit. Insert
the two telescopic rods with lower rods. Set the height you want. To do this,
2
open the screw, pull out the telescopic rod and then close the screw again.
Place the hanger with 4 clips onto the telescopic rods.
Put on the shirts air bag, and pull the elastic cord at the bottom over the
3
mounting flange.
Stk.
1
2
2
1
4
4
1
1