Getting Started; Installation Of Degudent Solaris Device; Connecting To The Power Supply; Inserting The Reference Cathode - DeguDent Solaris Instrucciones Para El Uso

5. Getting Started:

a. Installation of DeguDent Solaris Device
The device must be placed on a flat solid surface (standing base) at least 10 cm away from the wall
or other objects. It should be positioned horizontally. The electroplating liquid must be protected from
direct sunlight or other light sources.
b. Connecting to the Power Supply
Connect the mains cable to the fuse-protected circuit via a wall outlet. After connecting the mains
cable, switch on the device by pressing the black ON button at the rear.
c. Inserting the reference cathode (colour-coded yellow)
Before operating the device, the reference cathode must be connected to the device head.
A gold-plated connector for the reference cathode is located to the right of the temperature sensor.

6. System Advantages:

• Very high hardness
• Homogeneous appearance
• Very fine-grained structure
• 1 magnetic stir bar for all beakers and liquid amounts
• Just two beakers
• Each cathode can be selected with an individual coating thickness
• Overnight mode / overnight plating
• Extra beaker for possible later plaster release/rinsing
• Finer gradations of coating thicknesses
• Up to 16 objects can be plated
• The electroplating process lasts about 5 hours (200 µm)
• RS 232 interface for updates
• Clear display
• Self-explanatory user menu
• Anode heating (no risk of the housing being burned)
• Simple plug system for the cathodes
• Ready-to-use and recyclable steel cathodes
Please note: When starting the device for the first time, please clean its components
(anode, beaker, magnetic stir bar, glass etc.) with distilled water before you begin using it.
The anode should be cleaned with an anode cleaner.
}
of the electrodeposited objects
23