Set Up - RedMax BCZ350S Manual De Instrucciones

4. Set up

■ Fitting the J-handle
• Clip the loop handle onto the shaft. Note that the loop handle
must be fitted between the arrows on the shaft.
• Slide the spacer into the slot in the loop handle.
• Fit the nut, and screw. Do not overtighten.
• Attach the J-handle to the loop handle using the three screws,
as shown.
• Now adjust the trimmer to give a comfortable working position.
Tighten the bolt.
WARNING
• Only grass blades/grass cutters or trimmer heads/plastic
blades may be used when the J-handle is fitted.
• Saw blades must never be used with the J-handle.
■ Assembling the cutting equipment
WARNING
• When fitting the cutting attachment it is extremely
important that the raised section on the drive disc/ support
flange engages correctly in the centre hole of the cutting
attachment. If the cutting attachment is fitted incorrectly it
can result in serious and/or fatal personal injury.
WARNING
• Never use a cutting attachment without an approved guard.
• See the chapter on Technical data. If an incorrect or faulty
guard is fitted this can cause serious personal injury.
IMPORTANT
If a saw blade or grass blade are to be used the machine must be
equipped with the correct handlebar, blade guard and harness.
■ Fitting the guard extension
CAUTION! The guard extension shall always be fitted when
using the trimmer head/plastic blades and combination guard.
The guard extension shall always be removed when using the
grass blade and combination guard.
Enter the guard extension guide in the slot of the combination
guard. Then click the guard extension into position on the guard
with the four quick-fasteners.
BCZ350S
U
S
US-13