Starting And Stopping - RedMax BCZ350S Manual De Instrucciones

BCZ350S

6. Starting and stopping

■ Check before starting
• Check the blade to ensure that no cracks have formed at the
bottom of the teeth or by the centre hole. The most common
reason why cracks are formed is that sharp corners have been
formed at the bottom of the teeth while sharpening or that the
blade has been used with dull teeth. Discard a blade if cracks
are found.
• Check that the support flange is not cracked due to fatigue or
due to being tightened too much. Discard the support flange if it
is cracked.
• Ensure the locking nut has not lost its captive force. The nut
lock should have a locking force of at least 1.5 Nm. The
tightening torque of the locking nut should be 35-50 Nm.
• Check that the blade guard is not damaged or cracked.
Replace the blade guard if it is exposed to impact or is cracked.
• Check that the trimmer head and trimmer guard are not
damaged or cracked. Replace the trimmer head or trimmer
guard if they have been exposed to impact or are cracked.
US-18
• Never use the machine without a guard nor with a defective
guard.
• All covers must be correctly fitted and undamaged before you
start the machine.
■ Starting and stopping
WARNING
• The complete clutch cover and shaft must be fitted before
the machine is started, otherwise the clutch can come
loose and cause personal injury.
• Always move the machine away from the refuelling area
before starting. Place the machine on a flat surface. Ensure
the cutting attachment cannot come into contact with any
object.
• Make sure no unauthorised persons are in the working
area, otherwise there is a risk of serious personal injury.
The safety distance is 15 metres.
Starting
Primer bulb: Press the air purge repeatedly until fuel begins to fill
the bulb. The bulb need not be completely filled.