Safety System; Before First Use; Using The Appliance - Moulinex JU610D10 Manual De Instrucciones

CAUTION: the safety precautions are part of the appliance. Read them carefully before using
your new appliance for the first time. Keep them in a place where you can find and refer
to them later on.
DESCRIPTION
A Pusher
B Feed tube
C Cover
D Sieve
E Juice collector
F Pouring spout
G Pulp collector

SAFETY SYSTEM

This appliance is fitted with a safety mechanism. To start the juice machine, the cover (C) must
be properly secured by the safety clamp (H). Opening the safety clamp (H) will stop the juice
machine. At the end of a cycle, place the control knob (I) to 0 and wait until the sieve (D) stops
completely before removing the cover.

BEFORE FIRST USE

• We recommend that you wash all the removable parts (A, B, C, D, E, G, L) in warm soapy water
(see paragraph "Cleaning"). Rinse and dry them carefully.
• Unpack the appliance and place it on a clean, dry stable flat work surface away from water
splashes.
• Ensure that all packaging has been removed before starting the appliance.

USING THE APPLIANCE

• Place the juice collector (E) on the body of the appliance (see
• Place the sieve (D) in the juice collector (E). Ensure that the sieve is properly clipped onto
the drive shaft (J) (see
• Fit the pulp collector (G) on the rear of the appliance (see
• Fit the cover (C) on the appliance, spout to the rear (see
• Push the safety clamp (H) to the rear until it locks into place. You will hear an audible "click"
(see Fig. 5).
• Slide the pusher (A) into the feed tube (B) aligning the groove on the pusher with the small
ridge in the feed tube (see
• The juice jug (L) has a foam separator (N) that keeps the foam in the jug when you pour the
juice into a glass. If you do not want to separate the foam, remove the foam separator (N).
• Place the juice jug (L) under the pouring spout in front of the appliance (see
• Plug in the appliance.
• To start the appliance, use the control knob (I).
• Insert the fruits or vegetables through the feed tube (B).
26
Fig. 2).
Fig. 5).
H Safety clamp
I Control knob (2 speeds)
J Drive shaft
K Motor unit
L Juice jug
M Cleaning brush
N Foam separator
Fig. 1).
Fig. 3).
Fig. 4).
Fig. 6).