Safety System; Before First Use; Using The Appliance - Moulinex FRUTELIA+ MÉTAL JU420 Manual Del Usuario

DESCRIPTION
A Pusher
B Feeding tube
C Cover
D Sieve
E Juice collector
F Pouring Spout with anti-drip system

SAFETY SYSTEM

To start the juicer, the cover (C) must be fitted correctly (Fig. 2) and the clamps properly locked
(Fig. 4).
At the end of a cycle, turn the control button to "0" and wait until the sieve (D) stops completely
before removing the cover (C).

BEFORE FIRST USE

We recommend that you wash the removable parts (A, B, C, D, E, G) before the first use (see
section "Cleaning and care").
Unpack the appliance and then place it on a solid, stable worktop, remove the cover (C) and take
out the protective card on the sieve (D).

USING THE APPLIANCE

• Place the pulp container in the correct position (see Fig. 1)
• Place the juice collector (E) on the body of the appliance (see Fig. 2).
• Place the sieve (D) in the juice collector (E). Ensure that the sieve is properly clipped onto the
drive shaft (K) (see Fig. 2).
• Fit the cover (C) on the appliance in order to have the pulp evacuation exit to the rear
(see Fig. 3).
• Lock the two handles (H) on the cover (C). You will hear an audible "click" (see Fig. 4).
• Slide the pusher (A) into the feeding tube (B) aligning the groove on the pusher with the small
ridge in the feeding tube.
• Place a glass
(see Fig. 5).
• Make sure the spout is opened to let the juice flow.
• Plug in the appliance.
• To start the appliance, use the control button (I).
• Cut the fruits or vegetables into pieces if necessary after removing the stones.
• Insert the fruits or vegetables through the feeding tube (B).
• The fruits and vegetables must be inserted only while the motor is running.
• Do not press too hard on the pusher (A). Do not use any other utensil. NEVER push food with
your fingers.
• When you have finished, stop the appliance by turning the control button (I) to 0 and wait
until the sieve (D) stops completely.
under the pouring
G Pulp container
H Locking Handles
I Control button
J Motor unit
K Drive shaft
L Anti-slip feet
spout (F) in front of the appliance
EN
25