Brush Cleaning - Panasonic ES8026 Instrucciones De Operación

With the system outer foil in place,
apply some hand soap onto the outer
foil.
Turn the shaver on and pour some
water over the outer foil.
After about 10-20 seconds, turn the
shaver off.
Remove the system outer foil and
clean it with running water.
Wipe off any moisture from the
shaver with a dry cloth and remove
the protective cap to allow the sys-
tem outer foil to dry completely.

Brush cleaning

Squeeze the system outer foil re-
lease buttons and lift the system
outer foil upward to remove it (see
fig. 7). Remove the inner blades by
grasping them firmly at both ends
and pulling them straight away from
the shaver (see fig. 8). Clean the
outer foil, the shaver body and the
trimmer with the long side of the
brush. Clean the inner blades with
the short side of the brush. Do not
use the short brush to clean the outer
foil (see fig. 9).
Replacing shaving head
components
It is recommended that you replace
the outer foil at least every year and
the inner blade at least every two
years to maintain your shaver's cut-
ting performance.
Replacing the system outer foil
(see fig. 7)
Squeeze the system outer foil re-
lease buttons and lift the system
OS01J010_ES8026_EUR_E
outer foil upward to remove it. To in-
sert the new system outer foil, press
down until it snaps into place.
Replacing the inner blades
(see fig. 8)
Squeeze the foil frame release but-
tons and lift the foil frame upward to
remove it. Remove the inner blades,
one at a time, by grasping them firmly
at both ends and pulling straight
away from the shaver. To insert the
new inner blades, hold the blades,
one at a time, at both ends and press
downward until they snap into place.
For environmental protection and
recycling of materials
This shaver contains Nickel-Metal
Hydride battery(s).
Please make sure that the battery(s)
are disposed of at an officially as-
signed location, if there is one in your
country.
How to remove the built-in
rechargeable battery(s) before
disposal of the shaver
(see fig. 10)
The battery(s) in this shaver is not
intended to be replaced by consum-
ers. However, the battery(s) may be
replaced at an authorized service
center. The procedure described be-
low is intended only for removal of
the rechargeable battery(s) for the
purpose of proper disposal.
1. Remove the two screws (a).
2. Pull the chassis (b) out of the
housing.
3. Turn the chassis over and remove
the battery(s) (c).
7
7 1/25/02, 9:39 AM