SOLIS Barista Perfecta Plus Manual Del Usuario página 25

If you want to change the saved amount, simply press and hold the coffee button
●
again until the new amount has been dispensed and saved.
You can stop the extraction at any time by pushing the coffee button again.
●
In general:
As long as the two coffee buttons are flashing, the machine is heating up.
As soon as both coffee buttons constantly light up white, the machine is ready for
use.
While a coffee is being prepared, the pressed button flashes. If the coffee is prepared
for the first time and the coffee button is held down until the desired volume is in the
coffee cup, the Prog. button and the pressed coffee button flash during this time.
If you want to brew another cup remove the portafilter, tap the coffee
●
grounds out of the filter and rinse the portafilter clean with clear hot water.
CAUTION: The portafilter and the filter are hot! Afterwards dry the filter with a
clean towel. The filter is now ready for use again.
CAUTION:
Never leave the espresso machine unattended while brewing espresso!
Never touch the hot surfaces of the espresso machine. You could scald yourself!
The portafilter, the filter and the steam / hot water outlet are especially hot during
and after use!
s
ST E A MIN G M ILK FO R CAP P U CCI NO /
CA FF E LA TTE
The stainless steel steam / hot water wand with steaming nozzle of your Solis Barista
Perfetta Plus turns fresh, cold milk into creamy, warm, frothy milk to produce a de-
licious cappuccino or caffe latte.
Proceed as follows:
First, make an espresso in a bigger cup.
●
To activate the steam function for steaming milk, press the steam button
●
the operation mode (when both coffee buttons light up white): the button starts
flashing for as long as the machine is heating up for the steam function, the two
coffee buttons are meanwhile off. As soon as the steam button is constantly lit
up white, the steam function is ready for operation.
Pour fresh, cold milk into the milk jug up to the bottom end of the spout. Keep
●
in mind that the volume of cold milk doubles when it is steamed up.
As soon as the steam button is constantly lit up white, move the steam/hot water
●
wand with the thermo-insulated rubber handle so that it is positioned above the
holes in the drip grid.
Open the steam/hot water control all the way for a few seconds to flush out any
●
residual water in the steam wand. Turn off the control again.
EN
in
25