Cleaning And Maintenance - SOLIS Barista Perfecta Plus Manual Del Usuario

s
EN
C L EAN IN G AN D M A I N T E NA NCE
ATTENTION: Every time before cleaning, switch off the appliance, disconnect the
mains plug from the power outlet and let the appliance cool down.
Do not use abrasive or aggressive cleaning agents, rough sponges or cloths as they
might scratch the surface.
ATTENTION: Never immerse the espresso machine casing, the power cord or the
power plug in water or other liquids or allow the parts to come into contact with
them!
NOTE: The espresso machine parts and accessories are not dishwasher safe.
CLE A NING TH E FIL TE R A N D T HE PO RT A F I L T E R
■
Use the small needle of the cleaning tool to clean the hole of the dual wall filters.
●
The pin is not intended for the single wall filters.
Up to under the handle of the portafilter, place the dirty portafilter and the filter
●
in a container with mild detergent and hot water.
CLE A NING TH E S TE AM ING N OZ Z L E O F T H E ST EA M / H O T
■
WA TE R W AN D
Unscrew the steam nozzle from the steam / hot water wand. Rinse the steam
●
nozzle carefully in warm water and then re-rinse it with clear water.
Should the nozzle be blocked, insert the big needle of the cleaning tool into the
●
opening of the nozzle. If the nozzle still is clogged, first place the nozzle in a glass
of hot water, then use the needle again to remove the blockage.
Screw the nozzle back onto the steam/hot water wand.
●
C LEA NI NG T HE C A S IN G , THE C U P T R A Y
■
A N D THE WA TE R TA N K
Clean the casing, the cup tray and the water tank with a soft, slightly moist cloth,
then dry it with a dry cloth.
C LEA NI NG T HE D R IP T RA Y WIT H D RI P G RI D
■
Remove, empty and clean the drip tray with the drip grid at regular intervals but
●
every time it is full and the red float gauge is visible between the drip grid.
28