Utilitech Pro 6155W-PIR22 Manual Del Usuario página 5

5. Make sure wire connections are secure. Carefully place wires
into junction box. Position the light (A) cover plate over the
crossbar.
Note: Put the long mounting screw through the center hole and
into the crossbar and tighten the screw until secure. Insert
mounting screw cap (CC) into mounting screw hole. DO NOT
overtighten.
Hardware Used
Mounting screw cap
CC
IMPORTANT: After mounting the motion-activated light, apply silicone caulking compound
completely around the perimeter of the cover plate where the back of the cover plate meets
the mounting surface. Silicone caulking prevents water from seeping into the junction box.
CAUTION: Make sure motion detector head is not UPSIDE DOWN! Turn the head so the
controls face the ground. If the head is turned upside down, the motion detector can be
damaged by rain.
Ensure fixture is mounted as indicated by icon in lamp base. Do not mount UPSIDE DOWN! Failure
to do so could affect product performance.
Installation is now complete. Turn on power at circuit breaker and flip wall switch to ON position.
Wall switch must remain in the ON position for the motion detector to work properly.
x 1
5
5