SICO 3 Serie Manual Del Propietário página 11

UPPER CLAMP ASSEMBLY INSTALLED ON RAMP
LANDING
TURNAROUNDS AND LANDINGS - continued
6. Lift the landing or turnaround slightly as you slide
it toward the bottom edge of the ramp section
and engage the lower clamp assembly onto the
bottom end of the ramp section.
7. Attach the next ramp section to the landing or
turnaround in the same manner as the earlier
ramp sections were installed.
8. Install additional ramp sections as required until
another landing or turnaround is reached or until
the next section is the bridge section. If the next
part of the ramp system is a landing or turn
around, repeat the steps in this section. If the
next section is the bridge section, proceed to the
next section.
PAGE 11