SICO 3 Serie Manual Del Propietário página 9

RAMP CONNECTED TO UPPER CLAMP ASSEMBLY
SECURE RAMP IN PLACE USING HITCH PINS
ATTACH THE FIRST RAMP SECTION
10. With a person on each side of the ramp, lift the
upper end of the ramp (i.e., the end without the
legs) so that it is slightly higher than the stage
or landing to which it will connect.
11. Pull the ramp section toward the upper clamp
until the ramp section brackets are against the
flat plates of the upper clamp assembly.
12. Lower the ramp onto the support plate.
13. Secure the ramp in place using the hitch pins
that are part of the upper clamp assembly.
14. If the ramp is on an uneven floor, adjust the
glides to level the ramp as needed.
ATTACHING THE NEXT RAMP SECTION
1. If the next section is a ramp section with folding
legs (i.e., not a landing or turnaround or the bridge
ramp section or wedge ramp section), connect
the second ramp section to the bottom end of the
first ramp section the same way the first ramp
section was attached to the upper clamp.
2. Repeat this process until the next piece of the
ramp system is either the bridge section or a
landing or a turnaround.
3. If the next section of the ramp system is the bridge
section, skip the next section on turnarounds and
landings.
PAGE 9
(CONTINUED)