SICO 3 Serie Manual Del Propietário página 13

WHEN THE WEDGE RAMP SECTION CONNECTS TO A
LANDING OR TURNAROUND OR STAGE
SPECIAL CONNECTORS
SPECIAL CONNECTOR ATTACHED TO WEDGE
RAMP SECTION
The connector at the upper end of the wedge ramp
section is designed to connect to the lower end of
the bridge ramp section. When the wedge ramp
section connects to a stage or landing or turnaround,
two special connectors (part number 118309B) are
required to connect the wedge ramp section to an
upper clamp assembly.
1. Pin the square tube end of both of the special
connectors to the wedge ramp section assembly
using the hitch pins.
2. Push the wedge ramp section with the special
connectors attached against the upper clamp
assembly.
3. Secure the special connectors now attached
to the wedge ramp section to the upper clamp
assembly with the hitch pins.
PAGE 13