Installation Overview - SICO 3 Serie Manual Del Propietário

INSTALLATION OVERVIEW

Detailed instructions begin on the next page.
1. Plan the layout of the portable stages and the ramp
system.
2. Set up the stage system. See the instructions
supplied with the stage.
3. If there is a top landing, set up the top landing and
install the landing to stage connector, if required.
4. Attach the upper clamp assembly to the landing or
stage.
5. Connect the tallest ramp section to the upper clamp
assembly. Note the legs of the folding leg ramp
sections are toward the bottom of the ramp section.
Connect additional ramp sections as required by the
ramp layout.
6. If a ramp landing or turnaround is included in the
layout, set up the landing or turnaround, attach a
lower clamp assembly to the landing or turnaround
and connect the landing or platform to the bottom
end of the ramp section.
7. Repeat steps 4 through 6 as required for the ramp
layout.
8. When only the bridge section and wedge section
are left to install, position the wedge section and
then connect the bridge section between the wedge
section and the lowest folding leg section.
9. Install handrails and guardrails.
PAGE 4