SICO 3 Serie Manual Del Propietário página 6

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TOP LANDING INSTRUCTIONS
1. If the ramp will connect directly to the
stage without a separate landing, skip
this section and proceed to attaching the
upper clamp assembly.
2. If the top landing is the same type of
stage as the main stage units, set up the
landing unit and connect it to the main
stage units with the stage unit to unit
connectors; skip the rest of this section
and proceed to attaching the upper
clamp assembly.
3. If the top landing is a different type of
stage than the main stage units, a
landing to stage connector is required.
The width of this connector must match
the width of the landing edge that
connects to the main stage units.
4. Place the connector firmly against the
stage edge at the desired location.
Using the provided T-handle hex
wrench, tighten the socket head cap
screws for the two clamps directed
toward the main stage unit. Firm
pressure is needed to ensure the
connector is solidly attached to the
stage. Do not over tighten to prevent
damage to the stage.
5. Position the landing firmly against the
connector and tighten the screws for the
two clamps directed toward the landing.
LANDING TO STAGE CONNECTOR
LANDING TO STAGE CONNECTOR
LANDING & STAGE CONNECTED
PAGE 6
ATTACHED TO STAGE

Publicidad

Tabla de contenido
loading

Productos relacionados para SICO 3 Serie

Tabla de contenido