Remote control
Control Panel & Remote Control Operation
BUTTON
ON: Enables control panel functions and
remote control. Turns on flame effect.
OFF: Disables control panel functions and
remote control. Turns off flame effect.
POWER
TIMER button: Controls timer settings to
turn off fireplace at selected time.
Settings range from 0.5 hours to 7.5 hours.
TIMER
FLAME button: Makes flame effect
dimmer and brighter.
NOTE: Flame effect stays on until power
button is turned off. Flame effect must be
on for heater to turn on.
FLAME
HEATER button: Turns heater on and off.
NOTE: The heater only works when the
flame effect is on. If the flame effect is off,
the heater will not turn on.
NOTE: To prevent overheating, the heater
fan will blow cool air for 8-10 seconds
HEATER
before the heater turns on, and after the
heater turns off.
Controls LED back lights.
NOTE: The appliance will auto-cycle
through colours after pressing the button
11 times. It will be locked after pressing
the button 12 times, and the back lights
will be turned off after pressing the button
13 times.
FUNCTION
www.aflamo.com
Control Panel
ACTION & INDICATION
1. Press once. Indicator light turns on.
Power turns on. All functions enabled.
2. Press again. Flame effect turns off. Unit
goes to standby. All functions turn off.
1. Press once. Indicator light turns on.
Timer is set to 0.5 hours.
2. Press again until desired setting is
reached. Indicator lights show setting.
1. Press once. Flame brightness effect
gets changing.
2. Press again. until desired setting is
reached.
1. Press once. Indicator lights up.
Fan blows cool air for 10 seconds. 750W
heater turns on and blows warm air.
2. Press again. Indicator lights up.
1500W heater turns on and blows hot air.
3. Press again. Heaters turn off.
The fan blows cool air for 10 seconds to
allow heater to cool down, then turns off.
1. Press once. LED back light effect gets
changing.
2. Press again. until desired setting is
reached.
10 Settings: Orange, red, blue, yellow,
green, purple, azure, carmine, white, pink.
9