Automated Learning Process./Activating Code; Remote Control Operation; Testing Your Fan - Craftmade Bellows III Guia De Instalacion

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

9. Automated Learning Process./Activating Code.

CAUTION: The wall and/or handheld remote control can be programmed
to multiple receivers or fans. If this is not desired, turn wall switch off to
any other programmable receiver or fan.
Restore electrical power and then, if using wall control, set slider
switch on wall control to the ON position. Within 60 seconds of
turning on the wall control, press and hold the fan OFF button on the
wall control for 5 seconds (or until fan blades begin to turn.)
Turn power off again for at least 5 seconds and then turn power
back on. Within 60 seconds of restoring the power, press and hold the
fan OFF button on the handheld remote control for 5 seconds (or until
fan blades begin to turn.)
Test the fan function to confirm the learning process is complete--
see Section 11 below.

10. Remote Control Operation.

ON/OFF slider switch -
HIGH button -
MED button -
LOW button -
OFF button -
button -

11. Testing Your Fan.

It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light switch
(if applicable). Test wall control (optional installation) by
locating ON/OFF slider switch on wall control, then set to
the ON position. Test ROTATION/OFF function of main fan
with
button; test lower fan speeds with different fan
speed buttons and OFF button. Next, locate remote
control. Test fan speeds (and OFF) with the different fan
speed buttons and then test rotation of main fan (and OFF)
as was done with wall control. If the wall and/or remote
control(s) operate(s) all of the functions of the fan, battery
has been installed correctly in (each) remote. If the wall
and/or remote control(s) do (does) not operate all of the
fan functions, refer to "Troubleshooting" section to solve
any issues before contacting Customer Service.
The tilt angle of the lower fan may be adjusted up or down by simply
moving the fan motor gently up or down. [Tilt angle limit = 170°]
CAUTION: To avoid personal injury or damage to the fan, the fan
MUST BE TURNED OFF before adjusting the tilt angle.
turns wall control ON or OFF
(switch not functional on handheld remote)
turns lower fan to HIGH speed
turns lower fan to MEDIUM speed
turns lower fan to LOW speed
turns lower fan OFF
turns main fan ON/OFF
(i.e., controls ROTATION of the ENTIRE fan)
page 8
wall control
handheld
remote control
main
fan
motor
lower fan

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Bw321ag3Bw321ss3

Tabla de contenido