Brinkmann 810-3246-0 Manual Del Propietário página 9

INS_810-3246-0_BI.qxd
Hood Pivot Pin
12/28/07 3:24 PM Page 9
Handle
Hitch Pin
Step 11
Attach one handle stand using two
M6 x 12mm bolts and two
Handle
M6 nuts. Next insert hood handle into
Stands
handle stand. Place the other handle
stand over handle and attach by using
two M6 x 12mm bolts and two M6 nuts.
Step 12
Attach air vent dampers to the inside of lid.
Place air vent dampers on the inside of the
unit with the adjustment tab sticking
through one of the air vent holes. Using one
M6 X 12mm bolt and M6 nut, secure vent
cover to the unit. Do not over tighten the
nut as this will make the vent difficult to
open and close. Repeat for other air vent
damper.
Step 13
Attach one half of each hinge to the
outside back of the body using
M6 x 28mm bolts. Thread bolts into nuts
welded to the inside of the grill body but
do not tighten. Attach the other half of
each hinge to the outside back of the lid
using two M6 x 28mm bolts. Thread bolts
into nuts welded to the inside of the lid
but do not tighten. Repeat for other
hinge.
Step 14
Rest lid on the grill body and align hinges
to insert hood pivot pins. Insert hitch pins
into hood pivot pins. Tighten all hinge
screws on lid and grill body until secure.
Step 15
Insert adjuster cranks through front of
grill body and into crank brackets. Rotate
clockwise until cranks engage charcoal
grates.
8