What To Do If - Electrolux ERE 39353 X Manual De Instrucciones

Ocultar thumbs Ver también para ERE 39353 X:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

10 electrolux

WHAT TO DO IF...

During operation of the appliance some
smaller but annoying trouble can often oc-
cur, which does not require calling a techni-
cian out. In the following chart information is
given about them to avoid unnecessary
charges on service.
Important! The operation of the appliance
goes with certain sounds (compressor and
Problem
The appliance is noisy.
is displayed in the tem-
perature display
The compressor oper-
ates continually.
Water flows on the rear
plate of the refrigerator.
Water flows into the re-
frigerator.
Water flows on the
ground.
There is too much frost
and ice.
The temperature in the
appliance is too low.
Possible cause
The appliance is not supported
properly.
The spacers located between
the back of the cabinet and the
pipes come loose.
An error has occurred in measur-
ing the temperature
The Temperature regulator may
be set incorrectly.
The door is not closed correctly.
The door has been opened too
frequently.
The food temperature is too high. Let the food temperature de-
The room temperature is too
high.
During the automatic defrosting
process, frost defrosts on the
rear plate.
The water outlet is clogged.
Food prevent that water flows in-
to the water collector.
The melting water outlet does
not flow in the evaporative tray
above the compressor.
Food are not wrapped properly.
The door is not closed correctly.
The Temperature regulator may
be set incorrectly.
The Temperature regulator may
be set incorrectly.
circulating sound). This not means a
trouble, but a normal operation.
Important! The appliance operates
discontinuously, so the stopping of
compressor does not mean being no
current. That is why you must not touch the
electrical parts of the appliance before
breaking the circuit.
Check if the appliance stands sta-
ble (all feet and wheels should be
on the floor). Refer to "Levelling".
Put them back in place again.
Call your service representative
(the cooling system will continue
to keep food products cold, but
temperature adjustment will not
be possible)
Set a warmer temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
crease to room temperature be-
fore storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that food do not touch
the rear plate.
Attach the melting water outlet to
the evaporative tray.
Wrap the food better.
Refer to "Closing the door".
Set a higher temperature.
Set a higher temperature.
Solution

Publicidad

Tabla de contenido
loading

Tabla de contenido