Daily Maintenance - SportTech F50 Manual Del Usuario

14. DAILY MAINTENANCE

IMPORTANT REMINDER:
• Please don't clean the treadmill with sandpaper or solvent. The controller of treadmill shall not
be directly exposed to sunlight or damp to prevent damage.
• Frequently inspect and lock all parts of treadmill and immediately replace the damaged parts.
REGULATE RUNNING BELT
Adjustment of running belt is equipped with two functions: adjustment of degree of tightness and central position of
running belt. The running belt has been adjusted when leaving the factory, but it will be stretched after use to deviate
from central position to cause damage by wearing trim strip and rear protecting cover. It is normal for the running belt
to stretch in use.
ADJUST RUNNING BELT
If the running belt is slipping or not smooth when you use the treadmill, you can improve it by adjusting degree of
tightness of running belt.
HOW TO ADJUST RUNNING BELT
1. Insert 5mm hexagon wrench into the regulating screw on the left of running belt, and turn the wrench by 1/4 of
a circle clockwise to regulate the rear roller to tighten the running belt.
2. Repeat step 1 to adjust the screw on the right. Ensure that the regulating screw is turned by the same distance
to make the rear roller parallel with the frame.
3. Repeat step 1 and 2 until the running belt is not slipping.
4. Note: the running belt shall not be too tight, which will damage the running belt, roller bearing, etc., increase
pressure of front/rear roller, and bring abnormal sound or other problems. To reduce tension of running belt,
please turn the wrench anticlockwise by same distance on both sides.
86