Daily Maintenance - SportTech F75 Manual De Usuario

DAILY MAINTENANCE

Maintenance of electric treadmill
Appropriate maintenance is the only way to keep your treadmill in optimum state. Wrong maintenance
will damage or shorten the service life of treadmill.
Important reminder
1. Please don't clean the treadmill with sandpaper or solvent. The controller of treadmill shall not be
directly exposed to sunlight or damp to prevent damage.
2. Frequently inspect and lock all parts of treadmill and immediately replace the damaged parts.
Regulate running belt
Adjustment of running belt is equipped with two functions: adjustment of degree of tightness and
central position of running belt. The running belt has been adjusted when leaving the factory, but it will
be stretched after use to deviate from central position to cause damage by wearing trim strip and rear
protecting cover. It is normal to stretch the running belt in use.
Adjust running belt
If the running belt is slip or not smooth when you use the treadmill, you can improve it by adjusting
degree of tightness of running belt.
How to adjust running belt
1. Insert 5mm hexagon wrench into the regulating screw on the left of running belt, and turn the
wrench by l/4 of a circle clockwise to regulate the rear roller to tighten the running belt.
2. Repeat step 1 to adjust the screw on the right. Ensure that the regulating screw is turned by the
same distance to make the rear roller parallel with the frame.
3. Repeat step 1 and 2 until the running belt is not slip.
4. Note: the running belt shall not be too tight, which will damage the running belt, roller bearing, etc.,
increase pressure of front/rear roller, and bring abnormal sound or other problems. To reduce tension
of running belt, please turn the wrench anticlockwise by same distance on both sides.
Adjust running belt to the middle
When you use the treadmill, the force of feet is different, and pressure on running belt is unbalanced,
which makes the running belt deviate fiom the center. Such deviation is normal. It will return to the
center when nobody is running on the running belt. You need to adjust it to the center if it fails to return
to the center.
1. Keep the treadmill in no-load running and adjust speed to 6KM/H.
2. Observe the distance from running belt to left and right edgestrips
a. If the running belt tilts towards the left, turn the left screw by 1/4 of a circle clockwise with Allen
wrench.
b. If the running belt tilts towards the right, turn the right screw by 1/4 of a circle clockwise with Allen
wrench.
c. If the running belt is still not in the middle, repeat the above steps until it is in the middle.
80