Before Starting The Equipment; Continuous Operation; Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL TC-MX 1400 Manual De Instrucciones

ment is used and may exceed the specifi ed value
in exceptional circumstances.
The specifi ed vibration value can be used to
compare the equipment with other electric power
tools.
The specifi ed vibration value can be used for initi-
al assessment of a harmful eff ect.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
Mixer assembly (Fig. 2):
First scew mixer part (6a) together with mixer part
(6b). Screw the mixer (6) into the mixer holder (5)
afterwards. Use the two spanners to do this. Use
one of the spanners (a) to hold the mixer holder
Anl_SA_TC_MX_1400_SPK8.indb 25 Anl_SA_TC_MX_1400_SPK8.indb 25
GB
(5) in place and then use the second spanner (b)
to tighten up the mixer (6). Proceed in the reverse
sequence to undo the mixer.
is secure (pull the mains plug).
6. Operation
6.1 ON/OFF switch (Fig. 3/Item 1)
•
First fit a suitable mixing tool to the equipment
(see 5.)
•
Connect the mains plug to a suitable socket.
To switch on:
Press the ON/OFF switch (1)

Continuous operation:

Secure the ON/OFF switch (1) with the locking
button (2).
To switch off :
Press the ON/OFF switch (1) briefly.
6.2 Adjusting the speed (Fig. 1/Item 3)
Use the speed control (3) to pre-select the speed.
6.3 Changing over from 1st gear to 2nd gear
(Fig. 4 / Item 4)
You can work at a higher or lower speed
depending on the position of the selector switch.
To avoid damaging the gear unit you should only
change over gears when the tool has stopped.

7. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
- 25 -
23.08.2018 08:57:11 23.08.2018 08:57:11