Qlima Fiorina 74 S- Serie Manual De Instalación página 101

et before carrying out any maintenance
work on the stove.
• Disconnect the plug from the socket when
the heater is not in use.
• Do not modify the appliance. This is to
avoid hazardous situations arising. Any
modifications made would result in the
warranty becoming null and void.
• Store the installation and operating man-
ual in a safe place.
• In an emergency, always follow the instruc-
tions given by the fire brigade.
3. ASSEMBLY INSTRUCTIONS FOR THE PARTS SUPPLIED
3.1 ASSEMBLING THE DISPLAY (IF NOT PRE-INSTALLED)
G
Only applicable for models with majolica side panels.
Position the majolica side panels before fitting the display.
1. Remove the top plate of the stove. This plate is placed on the stove.
2. Loosen the two screws on the back of the stove (see Fig. 1) so that they fit
into the two openings on the display mounting plate.
3. Press the assembly rings around the two loose screws against the wall of the
stove.
4. Position the display plate openings between the bolt head and the ring (see
Fig. 2).
5. Then, tighten both screws in order to attach the display (see Fig. 3).
6. Make sure the flat cable can move freely behind the display plate.
7. Remove the protective material around the flat cable (see Fig. 4).
8. Place the flat cable in the protection channel (see Fig. 5).
3.2 POSITION THE ROOM TEMPERATURE SENSOR
The room temperature sensor is located at the back of the stove. Unwind the sen-
sor cable until the sensor tip is 5 cm from the floor (see Figure 6). Make sure that
the sensor does not come into contact with hot parts of the stove.
4. MINIMUM REQUIREMENTS FOR THE FLUE PIPE/CHIM-
NEY
The chimney/flue pipe is a very important part of the system.
This chapter deals with the minimum requirements that the chimney/flue pipe for
the pellet stove must meet to ensure the stove works properly.
4
101