Broan BXT1 Serie Manual Del Usuario página 5

USE AND CARE
ROCKER SWITCHES
Left rocker switch controls blower and right rocker switch controls light.
(FIG. 14)
BLOWER SWITCH
Turns blower on to HIGH speed.
o
Turns blower OFF.
Turns blower on to LOW speed.
CLEANING
Finish Keep your range hood clean using a mild detergent suitable for
painted surfaces.
The aluminum filter should be cleaned frequently. Use a warm
dishwashing detergent solution.
Clean all-metal filter using a non-phosphate detergent. Discoloration of the
filter may occur if using phosphate detergents, or as a result of local water
conditions - but this will not affect filter performance. This discoloration is
not covered by the warranty. To minimize or prevent discoloration, hand
wash filter using a mild detergent.
FILTER REMOVAL
Remove filter by pulling on its plastic tab.
LIGHT BULB REPLACEMENT
Replace the BXT Series range hood bulb using one LED light bulb (120 V,
7 W max., with GU10 base). Align the bulb leads with the small indentations
located on the border of the lamp location on hood (see inset in FIG. 15),
then install the bulb by placing the bulb leads into their grooves in the
socket. NOTE: Do not fold the plate (grey part in FIG. 15) located in the
light bulb housing. Gently push upwards and turn clockwise until secured.
If desired, one shielded halogen bulb can also be used
(GU10 base, 50 watts maximum).
!
Do not touch lamps during or soon after operation. Burns
may occur. In order to prevent the risk of personal injury,
only install shielded halogen lamps. Also, never install a
cool beam, a dichroic lamp, a lamp not suitable for use
in recessed luminaires or identified for use in enclosed
fixtures.
LIGHT SWITCH
Turns light ON.
o
Turns light OFF.
WARNING
FIG. 14
HC0094
FIG. 15
HO0352
- 5 -