Philips HP3631/01 Manual De Instrucciones página 9

3 Press the timer button to s et the desired treatment time (0-99 minutes). Keep the button
pressed to adjust the time more quickly. The set time is shown on the timer display.
Two seconds after releasing the timer button, the timer starts to count down in minutes. The
,
last minute is displayed in seconds. During countdown the remaining time blinks on the
display.
When the set time has elapsed, you hear an intermittent beep and 00 blinks on the display.
,
- Press the timer button to stop the beeping.
- If you don't press the timer button, the beeping will automatically stop after 45 seconds.
To change the set time during treatment, keep the timer button pressed for two seconds
,
until 00 appears on the display. Then use the timer button to set a new treatment time.
Note: The timer does not switch the appliance off. It only signals that the set time has elapsed.
cleaning
Unplug the appliance and let it cool down for about 15 minutes before you clean it.
Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone
to clean the appliance.
1 Clean the lamp housing and the base with a moist cloth. Do not let any water run into the
appliance.
2 You can clean the outside of the filter with a soft cloth sprinkled with some methylated
spirits.
storage
Do not let the cord come into contact with the filter when it is hot.
1 Unplug the appliance and let it cool down for about 15 minutes before you store it.
- Always lift or carry the appliance by its handgrip (Fig. 14).
2 Store the InfraCare in a dry place.
replacement
Filter
The filter protects against exposure to undesired light.
If the filter is damaged or broken, do not use the appliance anymore. Contact the Philips
Consumer Care Centre for information.
Note: If the filter breaks or becomes damaged during the guarantee period, contact the Consumer Care
Centre to have the appliance replaced.
lamp
The effectiveness of the lamp does not diminish in the course of time.
Do not attempt to replace the lamp if the lamp stops working. Contact the Philips Consumer
Care Centre for information.
Note: If the lamp stops working during the guarantee period, contact the Consumer Care Centre to have
the appliance replaced.
Battery
The battery compartment of the timer is located in a recess in the back of the appliance.
1 Remove the cover of the battery compartment by turning it to the left with a screwdriver.
EnglisH
9