Network Setting - ViewSonic IFP2410 Guia De Inicio Rapido

H. Network Setting
Connecting to Wireless LAN
1) Tap "All applications" – "Settings".
2) Turn "Wi-Fi" to ON by dragging "OFF" to the right.
3) When Wi-Fi is turned on, a list of all available wireless LAN access points will be shown on the right
side of the screen. Tap the desired Wireless LAN access point for the connection.
4) If a password is required, enter it and tap "Connect" to connect to the wireless LAN.
Connecting with RJ45
Simply plug in your Ethernet cable to the RJ45 port to connect to a LAN. No set-up or configuration is
required.
I. Restore to Factory
Resetting Your Smart Display
Restore to factory will delete all of your data created and installed apps after purchase (including system
and application settings, downloaded applications, etc.)
1) Tap "All applications" – "Settings".
2) Tap "Back up & reset".
3) Tap "Factory data reset".
4) Confirm all onscreen instructions and tap "reset".
5) Again, confirm all onscreen instructions and tap "Delete All". Restoring will begin shortly.
System will reboot several times during restore.
J. Use as HDMI Display
Depending on the mode selected, this product may be used as an HDMI display.
Android Mode Can be used as an Android device.
HDMI Mode Connect to HDMI source to use as a Monitor device.
Switching to HDMI Mode
1) Connect this display and an HDMI source with the HDMI cable. Optional accessory may not be
included with this product package in some regions.
2) Tap the SELECT icon
Switching to Android Mode
1) Tap the SELECT icon
to switch to HDMI mode.
to switch to Android mode.
11