Frequently Asked Questions - Campbell Hausfeld PW2575 Manual Del Producto

Operating Instructions and Parts Manual

Frequently Asked Questions

How do I start my pressure washer?
1. Make sure you have gas and oil in the engine.
2. Turn the water on, then trigger the gun to make sure the water will flow smoothly out of the nozzle.
3. Put the engine throttle control in the "Fast/Start" position. Set the shut off switch to "ON."
4. Push the engine primer bulb three times (if applicable) or set the choke to "ON."
5. Pull the trigger (to relieve any back pressure in the pump) while pulling the starter cord.
6. If the engine does not start after three tries, repeat Steps 4 and 5 (See Page 5).
what type of oil do I use?
Engine: The engine DOES NOT COME FILLED WITH OIL. See Page 10 for engine oil types and quantities.
Pump: The pump comes filled with the correct amount of oil and should not need changing or filling. Refer to Pages 9 and
10 of this manual for oil changing instructions, oil types and quantities.
why don't I have any water pressure?
• Is the water hose attached to the pressure washer?
• Is the water turned on?
• Check for any kinks, leaks, or blockage in the hoses, fittings, or the nozzle.
• Is the adjustable nozzle in the low psi position? If so, move it into the high psi position (See Page 7).
• Is the inlet filter screen free of debris? Check and remove debris if needed.
how do I get high pressure?
• For high pressure, move the nozzle into the high psi position (See Page 7).
how do I get the soap suction to work?
1. Connect the clear plastic chemical suction tube to the plastic hose barb on detergent tank.
2. Fill the detergent tank with detergent forumlated for use with pressure washers.
3. Move the nozzle into the low psi position (See Page 7).
why doesn't the pressure washer apply detergents with high pressure?
Detergents "bounce" off cleaning surfaces as fast as they are applied. The pressure washer's features allow for a detergent
to be drawn while in low pressure mode only. By applying detergent at low pressure, the effect of "bouncing" is reduced.
Also, detergents are only effective when time is allowed for them to work on the surface of whatever is being cleaned. After
applying the detergent, wait 1-3 minutes while it works, and then proceed to rinse the surface with high pressure.
We offer a high pressure soap lance as an accessory. Refer to page 13 for information about this accessory. Because of
"bouncing", this accessory is not intended to be used where a regular lance would be sufficient.
what maintenance do I need to perform on my pressure washer?
1. After turning off the pressure washer and the water, depressurize the hose by triggering the gun.
2. Remove the garden hose and high pressure hose from the pump.
3. Pull the start rope slowly five times to purge water from the pump. This will help protect the pump from damage.
4. Do not store your pressure washer in an area where the temperature will drop below 32° F.
5. Follow proper storage and winterizing instructions found on page 8.
what do I do if I'm missing a part?
Call Campbell Hausfeld at 1-800-330-0712 and we will promptly replace your missing parts. Do Not returN tHe PreSSure
WaSHer to tHe retaIler!
where can I buy accessories for my pressure washer?
• If you can't find accessories at the store where you purchased your pressure washer, call Campbell Hausfeld at 1-800-330-
0712 or visit our website at www.chpower.com.
who do I call if I have questions or problems?
Call Campbell Hausfeld at 1-800-330-0712 (u.S.a.)
www.chpower.com
2